How We Repair Your Kenmore Upright Freezer
Freezers and blast chillers keep food at or below 0°F, so a small fault can put a lot of stored food at risk.
Every Kenmore model has its own parts list, so we start with the model and serial number on the rating label. That tells us the correct parts and any known issues or service bulletins for your unit.
Common Upright Freezer Problems We Fix
Water leaking
A blocked defrost drain or a cracked drain pan.
Clicking but not starting
Usually the start relay or overload; sometimes the compressor itself.
Not freezing or food softening
A dirty condenser, a failed fan, a bad start relay or thermostat, or a defrost failure. Low refrigerant from a leak is checked if those are fine.
Heavy frost or ice build-up
A worn door gasket, a door that does not close fully, or a failed defrost heater or timer on frost-free models.
Runs all the time
Dirty coils, a bad gasket, a failing condenser fan or a freezer sitting in a space that is too hot or too cold for it.
Quick Checks Before You Call
These are safe for most owners and sometimes solve the problem without a visit:
- Check the thermostat setting and that the unit has power at the outlet.
- Make sure the door or lid closes tightly and the gasket is not torn.
- Clear frost thicker than a quarter inch on manual-defrost models.
- Check whether the freezer is in a garage that is colder or hotter than its rated range.
Still not working? Call (844) 442-1500 or try our troubleshooting wizard.
Our 5-Step Repair Process
- Call or book onlineTell us what your Kenmore upright freezer is doing and when it started. We schedule the first available visit.
- DiagnosisThe technician checks power, controls and the parts most likely to fail, using the model's service data and test modes.
- Upfront quoteYou get the cause, the repair and the price before any work starts. If repair does not make sense, we tell you.
- RepairWe install original or equivalent parts matched to your model and clean up when we are done.
- Test and warrantyWe run the appliance through a full cycle to confirm the fix. The repair is covered by our 90-day parts and labor warranty.
Parts We Replace Most Often
- Start relay and overload
- Thermostat or temperature control
- Condenser fan motor
- Defrost heater and timer
- Door gasket
- Lid hinges and switches
Cost and Lifespan
Most upright freezer repairs cost $150–$400 including parts and labor, and these appliances typically last 10–20 years. These are national estimates: your exact price comes after the diagnosis. Use the repair vs replace calculator to compare.
Keep It Running Longer
- Keep a thermometer inside and check it weekly
- Vacuum condenser coils twice a year
- Defrost manual models when frost reaches a quarter inch
Upright Freezer Repair in Tennessee
We repair upright freezers in 310 cities and towns across Tennessee. Very hot summers and occasional hard freezes in Tennessee put homes across the state refrigerators, ice makers and water lines through big swings.
Frequently Asked Questions
How much does Kenmore Upright Freezer Repair cost in Tennessee?
Most upright freezer repairs fall between $150–$400 including parts and labor. The final price depends on the part that failed and your model. You get an exact quote after the diagnosis and before any work starts.
Can you repair my upright freezer today?
Same-day visits depend on technician availability in Tennessee. Call (844) 442-1500 early in the day for the best chance of a same-day or next-day appointment.
Is the repair guaranteed?
Yes. Parts and labor are covered by our 90-day warranty. If the same problem comes back within that time, we return and fix it.
Do you work on all Kenmore models?
We repair current and older Kenmore models. Some discontinued parts can be hard to find; if that is the case for your model, we tell you before you pay for a repair.
Should I repair or replace my upright freezer?
A upright freezer typically lasts about 10 to 20 years. If yours is well inside that range and the repair costs less than half the price of a new one, repairing usually makes sense. Near the end of its life, or when the repair costs more than half of a replacement, replacing is often the better value. We give you an honest opinion either way.